|
|
 |
 |
| |
 Product
Support |
|
| |
Home > Product
Support > Technical
Information |
| |
Technical Information |
|
|
| |
 |
TFT-LCD
Monitor Screen Adjustment |
| |
AGM14T/15T TFT-LCD monitor
screen adjustment and resolution setting procedures
for IBM/IBM compatible computers with Windows based
OS system |
|
Adapter Setting Chart
for Macintosh |
| |
If you are a Mac user,
then you can check out our Macintosh Adapter Setting
Chart in order to use our LCD Monitor on your Macintosh. |
| |
|
|
|
|
TFT-LCD
Monitor Screen Adjustment  |
|
| |
| |
| AGM14T / 15T Monitor Screen Adjustment and Resolution
Setting Procedure for IBM / IBM Compatible Computers
with Windows based OS system |
| |
| *** Before adjusting the
monitor, all necessity drivers should be installed
to your System and resolution has to be set to
manufacturer's recommended preset of 1,024x768
@60Hz, 70Hz, 72Hz, or 75Hz. |
| |
| To check the resolution, press the "SELECT" button
on the monitor and highlight the "Information".
Information screen will have Resolution, Horizontal
and Vertical (Refresh rate) frequency information. |
| |
To change the resolution
to its factory recommended preset:
• On
a Windows 95 or 98, press right
button a Mouse
to execute the Pop-up menu
• Press "Properties" to execute
the "Display
Properties"
• Press "Setting" and change the resolution to 1,024 x 768
• Press "Apply" or "OK" to
select and press "OK" to
keep the selected resolution
• Go back to "Display Properties" - "Setting" - "Advanced
Properties" - "Adapter"
• On Adapter property, change the refresh rate to 60Hz, 70Hz, 72Hz, or 75Hz.
If you don't have these options, choose "Adapter
Default" |
|
Screen Adjustment Procedure:
• Execute Windows 95 or 98.
• Press "Start" and "Shut
Down" --
It will display moire on screen.
• Push "SELECT" button on the monitor
to execute the User's Control on_Screen-Display
and hightlight the "V-position" or "H-position" to
center the screen. Skip to next if screen is centered.
• Once centering is done, press "SELECT" button
to highlight the "Clock" and using ADJUST (+ or -) to reduce or get rid of the vertical display
noise (Jail bars).
• Once the vertical display noise disappears,
press "SELECT" buttton again to highlight
the "Clock Phase" and use "ADJUST" button
to reduce or get rid of the horizontal display
noise (Snowy effect).
• Exit the OSD by pressing two "SELECT" button
at the same time.
• On a Shut down menu, press "No" or "Cancel".
• Finally you have adjustment the monitor
and this point you should have a very sharp and
clear display monitor. If the current display does
not satisfy you, go back to "Screen
Adjustment Procedure" or change the refresh rate other
than your current selected refresh rate. |
|
|
| |
|
|
| |
|
|
|
